Everyone wants to load the stove at ten and find coals at seven. Doing it without coating the flue in creosote takes technique, not a bigger firebox.
Build a coal bed first
An overnight load goes onto a deep bed of coals, not onto bare grates. Rake the coals forward, spread them evenly, and give them air for five minutes so the new load catches quickly.
Load large, load full
Big splits packed tightly burn slower than small ones with air gaps. Fill the firebox front to back, leaving two inches at the top for the secondary burn to work. Loading loosely is the most common reason a stove will not hold heat.
Burn hot, then cut the air back
Leave the air control open until the wood is charred and the secondaries are firing — you will see the lazy flames at the top of the firebox. Only then reduce the air, in stages, over ten minutes. Closing it early is what smothers the fire and sends smoke up a cool flue.
Do not expect miracles from a cold flue
An exterior chimney that has cooled all evening will not support a long, slow burn: the gases condense before they leave the stack. In very cold weather, accept a shorter burn with more air and reload in the morning.
The morning after
Open the air fully, rake the coals together, and put a couple of small splits on before the big ones. Never poke a smouldering load into a fireball — you will singe your eyebrows and set off the alarm.
What to avoid
- Green wood, cardboard or pallet scraps for “long burns” — all make creosote.
- Closing the flue damper overnight on a live fire.
- Overfilling past the firebrick line or against the glass.
Written by admin How-to
