Every stove manual has a floor-protection table, and almost every table is quoted in R-value. Buying a pad because it looks right is how installations fail inspection.
Read the manual first
Find the “clearance to combustible floor” line. It will give either a required R-value (common in the US) or a construction specification such as “two inches of brick on a four-inch concrete slab” (still common in Canada). Both are requirements, not suggestions.
What R-value means in practice
R-value measures thermal resistance: higher is better. A typical requirement is R-1.0 to R-2.0. Manufacturers stack 1/2-inch cement board (about R-0.2) and other layers to reach the target, and a listed pad will state its tested value on the label.
Size and shape
Pads extend a specified distance in front of the loading door and to the sides. Measure from the appliance, not from the wall, and remember that a corner installation needs a corner pad. Oversized pads always pass; undersized ones never do.
Materials that work
- Tempered glass over cement board — clean, easy to wipe, sits flush with hardwood.
- Slate or soapstone — heat-tolerant, natural finish, heavy enough to stay put.
- Steel with a stone core — thin, precise, good for tight clearances.
Documentation
Keep the pad’s specification sheet with the stove manual. Insurers and inspectors ask for it, and it is the fastest way to prove compliance years later when the label has worn off.
Written by admin Installation
